Question

（1）圖1游標卡尺讀數為                                                                               mm．    

（2）某興趣小組的同學利用如圖2所示的實驗裝置，測量木塊與長木板之間的動摩擦因數，圖中長木板水平固定．                                                                                                                                    

①實驗過程中，打點計時器應接在交流電源上，調整定滑輪的高度，使繩子拉力方向跟平板平行．                        

②已知重力加速度為g，測得木塊的質量為M，                                                         

砝碼盤和砝碼的總質量為m，砝碼盤、砝碼和木塊                                                    

的加速度大小為a，則木塊與長木板之間的動摩擦                                                      

因數μ=                                                                                                           ．       

③實驗時，某同學得到一條紙帶，如圖3所示，每隔三個計時點取一個計數點，記為圖中0、1、2、3、4、5、6點．測得相鄰兩個計數點間的距離分別為s₁=0.96cm，s₂=2.88cm，s₃=4.80cm，s₄=6.72cm，s₅=8.64cm，s₆=10.56cm，打點計時器的電源頻率為50Hz．計算此紙帶的加速度大小a=                                                   m/s²，打計數點“4”時紙帶的速度大小v=                                         m/s．（保留兩位有效數字）

                          

                                                                                                                                 

Answer 1

（1）2.25；（2）②；③3.0；0.96．